1. Changes made to variables etc. through plug-in DO NOT TRIP the save required on close layout flag.

2. Commands 54 only seems to work if simulation is normal speed.

3. Command 55 does not seem to work at all.

note I'm assuming page http://en.3d-modellbahn.de/wiki/3415#Sec1_1_1 is still up to date.

OK so I can list groups... and I can get a list of what is selected....but how do I list which items are included in the group ?

 

Hi Trevor,

Commands 54 and 55 seem to work fine here. Command 54 always returns 1 if the simulation mode is enabled, independent of the animation speed.

Am 10.10.2016 um 16:12 schrieb trevor:

but how do I list which items are included in the group ?

This is currently not possible.

Kind regards,

Neo

>54
<1;0

 

I'm getting that... and 55 returns 1 but sim is still running.

I'm running the latest beta

Hi Trevor,

commands 54 and 55 don't operate on the animation state, but on the simulation mode, which can be toggled at the upper-left corner.

Kind regards,

Neo

1 minute ago, Neo said:

Hi Trevor,

commands 54 and 55 don't operate on the animation state, but on the simulation mode, which can be toggled at the upper-left corner.

Kind regards,

Neo

oic...

HMMM

Doesn't that make messing with variables and positions a tad scary if the simulation is still running?