aemartinez

Thank you very much! Located and tested both successfully! Best regards, Antonio.

Hello again! I am enjoying 3D-TrainStudio very much! Now, I have a bit complex desing, I was looking how to do a very important task I was not able to find... How to do a backup? I don't want to loose anything! Can I do individual desings backup, whole data base backup, both? Thank you very much in advance.

Thank you! It is a very good solution. I implemented it successfully in my design. Regards, Antonio. Madrid (Spain)  

Let me explain what I know about starting and stopping a train in a signal to clarify what I don't know: I know how to stop a train in a signal, as it is explained in the wiki (Single signal stop). I know how to start the train again with an event when the signal changes to "on" I know hot to put a variable in the speed selection to use is at the speed of the train when the signal goes on. But this gives me the same velocity for all the trains stopped in the track associated to this signal. I don't know how to replace this fixed variable with an object variable of the locomotive I'm starting, where I have the target speed of the locomotive... I understandd the indirect variable method in the program, but It seems the track object has no standard object variable with the train that is in it, that could be the easiest way to do what I want. Any help will be welcome. Thank you very much in advance!

Before reading this article, I was fool looking the way of turning the base visible again... Until I discovered the edge of the base remains visible, and clicking on it is possible to select it.  

Thank you very much for your comment (and yes, your English is goog, better than mine!) This was the "work around" I used to check the direction... :-) Anyway, It is a bit complex doing that in all the situation. Perhaps it could be a good enhancement for new versions, to be able to create directly the condition of the end the train enters the track, just as a suggestion. Thanks again and best regards, Antonio.

Hello, first thanks for your program. It's wonderful! I'm working in automatic control for my first track. One of the things that make this difficult is track events. The same even is triggered when a train enters the track on both track ends. This is bad in bi-directional tracks, when different actions should be performed according to the train direction. I've found some work arouds, but... are you planning some condition to detect the end of the track the train is entering? Thank you very much. Antonio.